Trim to Fit Information

Trim to Fit Instructions

STEP ONE

(First check the old footbed is a good fit) Remove old footbed from the boot

Step 1

STEP TWO

If the old footbed is a good fit, use it to mark the Svartz footbed trimming line

Step 2

STEP THREE

The line should be clearly marked. Add a little bit if the old footbed was too small. Reduce a little bit if the old footbed was too tight

Step 3

STEP FOUR

Use scissors to trim the Svartz footbed to the required size

Step 4

STEP FIVE

Don't cut too much - a full half size is only 6mm! If unsure, trim a bit at a time, you can always cut a little bit more off - but you can't add it back on again

Step 5

STEP SIX

Put the trimmed footbed into the boot to replace the old footbed. CHECK THE FIT -if it is still too tight, mark and trim a little more

Step 6